อะไหล่ชุดผลิตโอนโซน Ozone 30g Inner Enamel Tube Inner Ozone Generator (สินค้า Pre-Order)

>> แจ้งความต้องการสินค้า <<

.

• 18g:  233mm  272mm
• 30g:  292mm  332mm
• 40g:  411mm  450mm
• 60g:  551mm  590mm
• 80g:  656mm  696mm

1. the feeding sources is not clean or dry enough. We require pure oxygen, or dry and clean ambient air, with dew temperature -40degree.
2. The cooling water is not sufficient. (Vertically install the tube, make sure the cooling water go from the bottom to the top, so there is full water in the tube all the time. the cooling water temeperature should be within 8 degree difference compared the working environment temperature, to prevent condensate. Also, please check if cooling water is pure, if too much impurity, it can block the water inlet, so water can go in to cool the electrodes)
3. There is water back flow into the enamel tube. (When mix ozone with water, make sure using an efficient anti-back flow device, to prevent water back flow, The ozone tube should be placed in a higher position than the water flow, as well.)

รับประกันสินค้า 3 เดือน